Removing and replacing the Removing and replacing the serverserver rails rails
PrerequisitesPrerequisites
If you are replacing the server mounting rails from a threaded-hole server, make sure that you have a T-25 Torx screwdriver available.
About this taskAbout this task
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon indicates whether the action shown in
the image is for a round-hole, square-hole, or a threaded-hole server.
Round-hole server Square-hole server Threaded-hole server
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the server.
6. Place the server on a flat, level surface.
7. To remove the sliding rails, do the following:
To Next Page
Loading...
