e. Use a T-30 Torx screwdriver to tighten one pair of diagonally opposite heatsink screws (callouts 1 to 2), and then tighten the other
pair of heatsink screws (callouts 3 to 4).
25. Install the air baffle and other removed hardware components.
26. Install the access panel.
27. If the server was removed from an enclosure or a rack, reinstall it now.
28. Connect all peripheral cables to the server.
29. Connect each power cord to the server.
30. Connect each power cord to the power source.
31. Power up the server.
ResultsResults
The installation is complete.
To Next Page
Loading...
