6. Disconnect any cables from the storage controller.
Note the connection for each cable.
7. Remove the storage controller from the riser cage.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a DIMMRemoving and replacing a DIMM
PrerequisitesPrerequisites
Before replacing memory, read the memory configuration and population guidelines in the server user guide.
About this taskAbout this task
CAUTION:CAUTION:
Failure to properly handle DIMMs can damage DIMM components and the system board connector.
To identify DIMMs installed in the server, see "DIMM slot locations."
To Next Page
Loading...
