b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove all power supplies.
5. Remove the access panel .
6. Take note of port numbers and cables connections to risers and the system board.
7. Disconnect and remove all cables that are connected to risers or the system board.
8. Remove all riser cages .
9. Remove the controller.
10. Remove all fans.
11. Remove the OCP adapter.
12. Remove all DIMMs.
Be sure to note the DIMM slot locations in which each DIMM is installed. These components must be installed in the same locations on
the new system board.
13. Do the following:
14. Remove the processor heatsink assembly.
15. Loosen the system board thumbscrew, and then remove the system board.
ResultsResults
To replace the component:
1. Install the spare system board.
To Next Page
Loading...
