ResultsResults
To replace the component, reverse the removal procedure.
Removing a hot-plug SAS/SATA/NVMe driveRemoving a hot-plug SAS/SATA/NVMe drive
CAUTION:CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or blanks
installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug drive LED definitions.
2. Back up all server data on the drive.
3. Remove the drive.
Figure 1. Figure 1. SFF driveSFF drive
Figure 2. Figure 2. LFF driveLFF drive
To Next Page
Loading...
