HPE ProLiant DL360 - Removing and Replacing a GPU in the Primary Riser

Removing and replacing a GPU in the primary riserRemoving and replacing a GPU in the primary riser
ProcedureProcedure
1. Observe the following warning:
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel.
6. Remove the riser cage.
7. If needed, disconnect the GPU power cable and then remove the GPU from the riser.
If there is no power cable, remove the GPU:
Removing and replacing a GPU in the primary riser 143