Removing and replacing the 2 SFF drive cageRemoving and replacing the 2 SFF drive cage
ProcedureProcedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack ( Extend the server from the rack ).
b. Remove the server from the rack (Remove the server from the rack ).
4. Remove the access panel (Remove the access panel).
5. Remove drives and drive blanks.
Note where each drive is located.
6. Disconnect all cables from the drive backplane.
7. Remove the drive cage.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
