Removing and replacing the rear SFF drive cageRemoving and replacing the rear SFF drive cage
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Remove the drive or drive blank from the drive cage.
6. Disconnect all cables from the drive backplane.
7. Remove the drive cage.
8. Remove the slot 2 bracket from the riser cage.
To Next Page
Loading...
