1. Observe the following alerts:
CAUTION:CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or
install the processor in this server.
CAUTION:CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must
contain processors with the same part number.
CAUTION:CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support Center websiteHewlett Packard Enterprise Support Center website .
CAUTION:CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or processor,
do not touch the contacts.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
5. Remove the access panel.
6. Remove the air baffle
7. Remove the heatsink blank.
8. Install the processor:
a. Hold the processor by its carrier handle.
b. Slide the processor into the rail frame until it engages with a click sound.
To Next Page
Loading...
