9. Hold the lift tabs and pivot the rail frame to the closed position.
A click sound indicates that the rail frame is properly engaged.
10. Close the retention frame:
a. When using a torque wrench to tighten the retention frame screw, set a torque between 1.24 N-m (11 lbf-in) to 1.47 N-m (13 lbf-in) .
b. Pivot the spring loaded retention frame downward and hold it down (callout 1).
c. Tighten the retention frame screw (callout 2).
11. If you are using the same heatsink, apply the full content of the thermal grease syringes on top of the processor. Follow the pattern
shown in the following image.
To Next Page
Loading...
