7. Install the expansion board into the PCI riser cage.
8. Install the riser cage.
9. Connect any required internal or external cables to the expansion board. See the documentation that
ships with the expansion board.
10. Install the access panel (Installing the access panel on page 37).
11. Install the server into the rack (Installing the server into the rack on page 53).
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server on page 32.
Installing the HPE 12G SAS Expander Card
Hewlett Packard Enterprise recommends installing the SAS expander card in the following locations:
88 Installing the HPE 12G SAS Expander Card
To Next Page
Loading...
