4. Press Esc until the main menu is displayed.
5. Select Reboot the System to exit the utility and resume the boot process.
Installing a processor
The server supports installation of 1–4 processors.
NOTE:
Single-processor configurations are supported in servers with only a six-slot riser installed in the primary riser
cage.
Hewlett Packard Enterprise recommends identifying the processor heatsink module components (Processor,
heatsink, and socket components on page 25) before performing this procedure.
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
• T-30 Torx screwdriver
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Observe the following alerts:
CAUTION:
When handling the heatsink, always hold it along the top and bottom of the fins. Holding it from the
sides can damage the fins.
CAUTION:
To avoid damage to the processor or system board, only authorized personnel should attempt to
replace or install the processor in this server.
CAUTION:
To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION:
If installing a processor with a faster speed, update the system ROM before installing the
processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise
Support Center website.
CAUTION:
THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket
or processor, do not touch the contacts.
2. Power down the server on page 32.
Installing a processor 99
To Next Page
Loading...
