3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack (Extending the server from the rack on page 32).
• Remove the server from the rack (Removing the server from the rack on page 33).
5. Remove the access panel (Removing the access panel on page 36).
CAUTION:
Do not operate the server for long periods with the access panel open or removed. Operating the
server in this manner results in improper airflow and improper cooling that can lead to thermal
damage.
6. Remove the primary PCIe riser cage (Removing a PCIe riser cage on page 39).
7. If installed, remove the butterfly riser cage (Removing a PCIe riser cage on page 39).
8. Remove the air baffle (Removing the air baffle on page 40).
9. If installed, remove the processor mezzanine tray (Removing the processor mezzanine tray on page
45).
10. Install the processor heatsink assembly:
a. Locate the Pin 1 indicator on the processor carrier and the socket.
b. Align the processor heatsink assembly with the heatsink alignment pins and gently lower it down until
it sits evenly on the socket.
The heatsink alignment pins are keyed. The processor heatsink assembly will only install one way.
Your heatsink may look different than the one shown.
100 Installing hardware options
To Next Page
Loading...
