HPE ProLiant DL580 Gen10 - Installing a Hot-Plug SAS or SATA Drive

22. If removed, do one of the following:
• Install the processor mezzanine tray (Installing a processor mezzanine tray on page 102).
• Install the 2P pass-through performance board (Installing the 2P pass-through performance board
on page 107).
23. Install the air baffle (Installing the air baffle on page 41).
CAUTION:
To avoid damaging the connectors, always install the air baffle into the server before installing the
riser cages.
24. Install the primary PCIe riser cage (Installing the primary PCIe riser cage on page 38).
25. Install the butterfly PCIe riser cage (Installing a butterfly PCIe riser cage on page 80).
26. Install the access panel (Installing the access panel on page 37).
27. Install the server into the rack (Installing the server into the rack on page 53).
28. Connect each power cord to the server.
29. Connect each power cord to the power source.
30. Power up the server on page 32.
Installing a hot-plug SAS or SATA drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all device bays are
populated with either a component or a blank.
Procedure
1. Remove the drive blank.
2. Prepare the drive.
74 Installing a hot-plug SAS or SATA drive