23. Power up the server on page 38.
24. Install the front bezel on page 40.
25. Perform the verification and configuration procedures required by the drive option
For more information, see the drive user guide from the Storage section of the Hewlett Packard
Enterprise Information Library.
The installation is complete.
Optical drive cage option
The server supports an optical drive cage option that allows the installation of a 9.5 mm optical drive.
Kit contents
• Optical drive cage
• Optical drive cage screws (2)
• Optical drive SATA-power cable
Installing a SATA optical drive
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Optical drive cage option
◦ Optical drive
◦ Optical drive bracket
◦ Optical drive bracket screws (2)
◦ The SATA-power cable that ships with the drive option will not be used in this server
• T-15 Torx screwdriver
• Phillips No. 1 screwdriver
Procedure
1. Remove the front bezel on page 39.
2. Power down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration on page 41.
• Server in rack mode: Extend the server from the rack on page 43.
6. Remove the access panel on page 48.
7. Remove the air baffle on page 50.
8. If installed, remove the fan cage.
9. While pressing the latch on the optical drive blank, pull out the blank from the bay.
Retain the blank for future use.
104 Optical drive cage option
To Next Page
Loading...
