Remove a PCI board screw
Prerequisites
Before you perform this procedure, make sure that you have T-15 Torx screwdriver available.
Procedure
If the standup plug-in board option kit does not include a screw for installation, remove one of the preinstalled
T-15 Torx screws underneath the PCI blank retainer deck.
Install the PCI blank retainer
Procedure
1. Install the PCI blank retainer:
a. Insert the tabs on the top edge of the retainer into the corresponding slots on the chassis.
b. Slide down the retainer until the horizontal part is flushed against the top side of the slot blanks.
58 Remove a PCI board screw
To Next Page
Loading...
