22. Do one of the following:
• Server in tower mode: Position the tower server for operation on page 42.
• Server in rack mode: Slide the server into the rack on page 47.
23. Connect all necessary external cabling to the expansion board.
For more information on the cabling requirements, see the documentation that ships with the option.
24. Connect all peripheral cables to the server.
25. Connect each power cord to the server.
26. Connect each power cord to the power source.
27. Power up the server on page 38.
28. Install the front bezel on page 40.
The installation is complete.
HPE 12G SAS expander card option
The HPE 12G SAS Expander Card connects to a Smart Array E-class and P-class Gen10 controllers. In this
server, this expander card supports the 24 SFF hot-plug drive configuration.
Kit contents
• HPE 12G SAS Expander Card
• Expander card to backplane Mini-SAS X-cables (3)
• Expander card to standup controller Mini-SAS X-cable
• Expander card to modular controller Mini-SAS X-cable
SAS expander card port numbering
HPE 12G SAS expander card option 127
To Next Page
Loading...
