3. Connect the power cord to the power supply.
4. Secure the power cord in the strain relief strap attached to the power supply handle:
a. Unwrap the strain relief strap from the power supply handle.
CAUTION:
Avoid tight bend radii to prevent damaging the internal wires of a power cord or a server cable.
Never bend power cords and server cables tight enough to cause a crease in the sheathing.
b. Secure the power cord with the strain relief strap. Roll the extra length of the strap around the power
supply handle.
5. Connect the power cord to the power source.
6. Make sure that the power supply LED is green.
Install a DC power supply
The following input power cord option might be purchased from an authorized Hewlett Packard Enterprise
reseller:
J6X43A—HPE 12 AWG 48 V DC 3.0 m Power Cord
If you are not using an input power cord option, the power supply cabling should be made in consultation with
a licensed electrician and be compliant with local code.
72 Install a DC power supply
To Next Page
Loading...
