Fan cage option
The server supports a fan cage option. This fan cage is required for specific hardware configurations.
Kit contents
• Fan cage with four preinstalled fans
• Fan cage brackets (2)
Fan cage implementation
The fan cage is required to meet the system thermal requirements for the following configurations:
• Server operating in rack mode
• Dual-processor configuration
• Server with the following drive box configurations:
◦ The maximum number of drives is installed in boxes 1, 2, and 3 (12 drives for LFF configuration, 24
drives for SFF configuration).
◦ The maximum number of drives is installed in boxes 2 and 3, and at least two media devices are
installed.
• Server with the following options installed:
◦ NVMe SSDs
◦ M.2 SSDs
◦ SFF SAS drives with 10K or 15K rpm rate
◦ Smart Array P-class 800-series Gen10 controllers*
◦ GPUs*
◦ HPE EDR InfiniBand adapters*
◦ High-performance NIC controllers*
For specific models covered by the options marked with an asterisk (*), see the product QuickSpecs on
the server website at http://www.hpe.com/servers/ml350-gen10.
• ASHRAE A3 and A4 compliant configurations
For more information, see the Hewlett Packard Enterprise website.
Fan population and hot-plug support
The number of fans installed in the server determines fan redundancy. When redundant fan mode is enabled,
hot-plug fan operation is supported.
In this server, fan operation can either be one of the following:
• Hot-plug – A failed fan can be replaced without powering down the server
• Non-hot-plug – To replace a failed fan, the user must either:
◦ Keep the server powered on and complete the fan replacement within 30 seconds of opening the
access panel, or
◦ Power down and disconnect all power from the server before removing the access panel for fan
replacement.
Fan cage option 107
To Next Page
Loading...
