4. Press and hold the blue rail-release tabs, and then slide the tray back into the rack.
Install the cable management arm
The cable management arm allows the server to be fully extended from the rack without the need to power off
the system or disconnect any rear panel cables. This CMA is designed for ambidextrous implementation.
CAUTION:
Support the CMA during the installation. Do not allow the CMA to hang by its own weight until it is
secured from all three connection points.
Procedure
1. Connect all peripheral cables and power cords to the rear panel.
2. Install the CMA:
a. Fasten the inner retention connector to left sliding rail hook.
b. Fasten the outer retention connector to left mounting rail hook.
c. Fasten the hinged connector to right mounting rail hook.
Install the cable management arm 85
To Next Page
Loading...
