• Server in tower mode: Position the tower server for hardware configuration on page 41.
• Server in rack mode: Extend the server from the rack on page 43.
6. Remove the access panel on page 48.
7. Remove the air baffle on page 50.
8. While holding the snap-in latch in the open position, slide the holder up to disengage it from the chassis.
9. Install the Smart Storage Battery into the holder:
a. Route the battery cable through the holder cutout marked with a down arrow.
b. Install the battery in the holder.
10. Secure the battery cable through the holder cable clips.
122 Hardware options installation
To Next Page
Loading...
