Hardware options installation 110
13.
Connect the LFF media power cable.
14. Connect the data cable to the media device.
Cable routing to connect a SATA device
15. Install the fan cage (on page 38).
16. Install the air baffle (on page 35).
17. Install the access panel (on page 33).
18. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Power up the server ("Powering up the server" on page 30).
22. Do one of the following:
o For tower models, install the tower bezel (on page 31).
To Next Page
Loading...
