Hardware options installation 132
7.
Install the TPM board. Press down on the connector to seat the board ("System board components"
on page 15).
8. Install the TPM security rivet by pressing the rivet firmly into the system board.
9. Install the air baffle (on page 35).
10. Install the access panel (on page 33).
11. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server ("Powering up the server" on page 30).
15. Do one of the following:
o For tower models, install the tower bezel (on page 31).
o For rack models, install the security bezel ("Security bezel option" on page 50).
To Next Page
Loading...
