Hardware options installation 84
9.
Install the Express bay drive cage assembly:
a. Remove the drive cage blank from box 1 or 4.
b. Install the Express bay drive cage and backplane assembly.
c. Connect the 2x4 connector of the power Y-cable to the Express bay drive cage backplane.
d. Connect the other two ends of the power Y-cable to the cable connectors from the server power
supply backplane.
e. Connect the three Express bay data cables to the Express bay drive cage backplane.
10. Install the Express bay bridge card in PCIe slot 3, 6, or 8:
NOTE: A second processor must be installed if the Express bay bridge card is installed in
PCIe slot 6 or 8.
To Next Page
Loading...
