Racing Kit
2-12
Before riding the machine, secure the following bolts and nuts:
– Engine oil return joint or oil filler cap
– Drive sprocket bolt
– Oil filter cartridge
– Oil cooler bolt
– Engine oil drain plug
1. Insert the proper length locking wire to the bolt.
2. Twist the wire using a commercially available wire twisting tool.
3. Insert the wire in the other side hole, and twist the wire.
4. Cut off any excess wire.
Wire twisting tool
No good Good
Wire Lock
• Use new 0.8 mm (0.03 in) stainless wire.
• Secure the bolt as shown so that it cannot come loose.
•Twisting the wire too tightly will break a locking wire.
Drill hole (3 - 4 mm)
Drill hole (3 - 4 mm)
Drain plug
Oil filter cartridge
Oil filler cap
Sub-tank band
Oil return joint
Drive sprocket bolt
Oil cooler bolt
To Next Page
Loading...
