HS-Technik NutBee NBPS-21 - Press Start Button; Front LED

- 23 -
 
Pressing or actuang the start buon starts or stops the tool.
NOTE
The battery riveting tool only starts when the battery has sufficient capacity.
* Start buon
 
WARNING

Looking directly into the light emitting diode can lead to eye injuries.
• Never look directly into the light emitting diode.
The LED on the front of the tool is used to illuminate the assembly area. Aer pressing
the start buon, the LED lights up. It turns o automacally aer a few seconds. The af-
terglow me of the LED can be parametrised in the HST-Tool-Manager under „setup“ →
„general“ → „energy&lighng“.
* Front LED
*
*