HS-Technik NutBee NBPS-21 - Service Interval Counter

- 66 -
 
The tool has an internal service interval counter which will inform the user of an inspecon
due. In this case you will receive the following nocaon in the display:
The service counters can be parametrised with the HST-Tool-Manager under the „Service“
user. The respecve value entered will be mulplied by 1,000, i.e. when entering 10 the
service nocaon will appear on the display aer 10,000 sets. If you enter 0 the funcon
is deacvated.
The recommended service intervals are saved in the tool ex works. We would be happy to
inspect the tools for you aer reaching the service interval.
19320012
SERVICE B