HS-Technik NutBee NBPS-21 - Spinning off; Tool Tilted or Blocked

- 28 -
4.2.9 Spinning off
If an incorrect nut or screw is spun on or it is not currently needed it can easily be spun o.
Clicking the yellow display buon will make the nocaon
„BACK“ appear in the display. The tool is ready to spin o the
blind rivet nut or blind rivet bolt next.
To do this, hold it rmly at the front.
Aer spinning o the tool will automacally go back to its normal operang state.
DANGER

The nose assembly is a moving component that heats up during the process
and can cause crushing.
• Under no circumstances should you touch parts of the nose assembly
during the process.
 
If the tool or the blind rivet nut becomes lted and stuck there is
an opon to release it on the back of the tool using a size 4 mm
Allen key aer the baery has been removed. To do this, place
the Allen key in the opening provided (1) and turn it counter-
clockwise. Always keep a rm hold on the tool.
DANGER

If the Allen key remains in the tool, it creates significant risk of injury.
• Prior to operation ensure that the Allen key has been removed.
1
P01 000/003
BACK