HS-Technik NutBee NBPS-21 - Page 41

- 41 -
„manual mode acve“ If the checkbox is acvated, the tool works in manual mode. In other
words, the standard program (yellow star) is always executed. In this
mode, the counng funcon, Wi-Fi and barcode are deacvated.
„enable over“
Use the drop-down menu to select how the tool is to be enabled. To use
this function, manual mode must be deactivated.
- „trigger“
The start buon must be pressed 3 mes in quick succession to enable
the tool. The tool then works in the standard program with the counter
acvated.
- „me“
A me must be entered aer which the tool is enabled. The tool then
works in the standard program with the counter acvated.
- „trigger & me“
A combinaon of the funcons described above. The condion that
is reached rst enables the tool. The tool then works in the standard
program with the counter acvated.
- „barcode“
Acvates the barcode scanner in the tool. A barcode must be scanned
to enable the tool. For more informaon on programming barcodes,
see the HST-Tool-Manager's operang instrucons.
- „external control unit“
Acvates the Wi-Fi in the tool. The tool is now enabled by an external
controller. Without being enabled, the tool is locked.
- „barcode & external control unit“
Acvates the barcode scanner and Wi-Fi. The tool scans a barcode
which is then sent to the external controller. Based on the scan, the
tool is enabled via Wi-Fi by the external controller.
„waing me between
ghtenings“
If the funcon is acvated, a me must be entered for the waing me
between two riveng operaons. For this me, the tool is without func-
on between the rivets and does not start up.
„abort on the display“ If the funcon is acvated, a me must be entered for the job to be
cancelled. The yellow menu key must be pressed for this me to cancel
a job.