HS-Technik NutBee NBPS-21 - Page 63

- 63 -
„record graph I
start
“ If this checkbox is selected, graphic recording starts from the entered
current value.
„1xNOK → cancel job“ If this checkbox is selected, the program is aborted in the event of an
NOK.

„F
min
“ F
min
describes the minimum force for this step. If a force below this value
is reached, no rivet has been set. The tool shows "Blank stroke" or "Leer-
hub" on the display, depending on the language seng (see pictures on
page 62).
„pressure trigger“ The pressure control ensures that the blind rivet can only be processed
when the pressure control is acvated. This prevents accidental trigger-
ing and ensures that the components to be processed are in contact
with each other.
Pressure control is only acve if the checkbox is enabled.
„conrm OK“ If this checkbox is selected, an OK seng must be acknowledged
„record graph F
start
“ If this checkbox is selected, graphic recording starts from the entered
force value.
„1xNOK → cancel job“ If this checkbox is selected, the program is aborted in the event of an
NOK.