LTE TDD B2268H
User Guide
Copyright © Huawei Technologies Co., Ltd.
Figure 6-1 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 6-1 Network Setting > Home Networking > LAN Setup
Enter the LAN IP address you want to assign to your
LTE Device in dotted decimal notation, for example,
192.168.1.1 (factory default).
Type the subnet mask of your network in dotted
decimal notation, for example 255.255.255.0 (factory
default). Your LTE Device automatically computes the
subnet mask based on the IP address you enter, so do
not change this field unless you are instructed to do so.
Select Enable to have your LTE Device assign IP
addresses, an IP default gateway and DNS servers to
LAN computers and other devices that are DHCP
clients.
If you select Disable, you need to manually configure
the IP addresses of the computers and other devices on
your LAN.
When DHCP is used, the following fields need to be
set.
This field specifies the first of the contiguous addresses in
the IP address pool.
This field specifies the size, or count of the IP address pool.
To Next Page
Loading...
