LTE TDD B2268H
User Guide
Copyright © Huawei Technologies Co., Ltd.
Select From ISP if your ISP dynamically assigns DNS
server information (and the LTE Device's WAN IP address).
Select DNS-Proxy to have the LTE Device send its own
address to the LAN clients for them to use as the DNS server.
Select User-Defined if you have the IP address of a DNS
server. Enter the DNS server's IP address in the field to the
right. If you chose User- Defined, but leave the IP address
set to 0.0.0.0, User-Defined changes to None after you click
Apply. If you set a second choice to User-Defined, and enter
the same IP address, the second User-Defined changes to
None after you click Apply.
Select None if you do not want to configure DNS servers.
You must have another DHCP sever on your LAN, or else
the computers must have their DNS server addresses
manually configured. If you do not configure a DNS server,
you must know the IP address of a computer in order to
access it.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
6.3 The Static DHCP Screen
This table allows you to assign IP addresses on the LAN to specific individual computers based
on their MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address
is assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02.
6.3.1 Before You Begin
Find out the MAC addresses of your network devices if you intend to add them to the Static
DHCP screen.
Use this screen to change your LTE Device's static DHCP settings. Click Network Setting >
Home Networking > Static DHCP to open the following screen.
Figure 6-2 Network Setting > Home Networking > Static DHCP
The following table describes the labels in this screen.
To Next Page
Loading...
