LTE TDD B2268H
User Guide
Copyright © Huawei Technologies Co., Ltd.
The PIN is not necessary when you use WPS push-button method.
Click the Generate New PIN button to have the LTE Device create a
new PIN.
This displays Configured when the LTE Device has connected to a
wireless network using WPS or Enable WPS is selected and wireless or
wireless security settings have been changed. The current wireless and
wireless security settings also appear in the screen.
This displays Not Configured when there is no wireless or wireless
security changes on the LTE Device or you click Release Configuration
to remove the configured wireless and wireless security settings.
This button is available when the WPS status is Configured.
Click this button to remove all configured wireless and wireless security
settings for WPS connections on the LTE Device.
This is the 802.11 mode used. Only compliant WLAN devices can
associate with the LTE Device.
This is the name of the wireless network.
This is the type of wireless security employed by the network.
Click Apply to save your changes.
5.5 The WMM Screen
Use this screen to enable or disable WiFi MultiMedia (WMM) wireless networks for
multimedia applications.
Click Network Setting > Wireless > WMM. The following screen displays.
Figure 5-10 Network Setting>Wireless>WMM
The following table describesthelabelsinthisscreen.
Table 5-9 Network Setting > Wireless > WMM
This enables the LTE Device to automatically give a service a priority
level according to the ToS value in the IP header of packets it sends.
To Next Page
Loading...
