LTE TDD B2268H
User Guide
Copyright © Huawei Technologies Co., Ltd.
This shows the MAC address of the wireless interface on the LTE
Device when wireless LAN is enabled.
Select Basic (WEP) or More Secure (WPA(2)-PSK, WPA(2)) to add
security on this wireless network. The wireless clients which want to
associate to this network must have same wireless security settings as the
LTE Device. After you select to use a security, additional options
appears in this screen.
Or you can select No Security to allow any client to associate this
network without any data encryption or authentication.
See Section 5.2.1 for more details about this field.
Click Apply to save your changes.
Click Back to exit this screen without saving.
5.4 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your LTE Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See 5.7.6 WiFi Protected Setup (WPS) for more information about
WPS.
The LTE Device applies the security settings of the SSID1 profile (see 5.2 The Wireless General
Screen ). If you want to use the WPS feature, make sure you have set the security mode of SSID1 to
WPA-PSK, WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and
click Apply to activate the WPS function. Then you can configure the WPS settings in this
screen.
To Next Page
Loading...
