LTE TDD B2268H
User Guide
8 Network Address Translation (NAT)
Copyright © Huawei Technologies Co., Ltd.
Select the protocol supported by this virtual server. Choices are TCP,
UDP, or TCP/UDP.
Click Apply to save your changes.
Click Back to return to the previous screen without saving.
8.3 The DMZ Screen
Use this page to set the IP address of your network DMZ (if you have one) for the LTE Device.
All incoming packets received by this LTE Device's WAN interface will be forwarded to the
default server you set.
Click Network Setting > NAT > DMZ to display the following screen.
The configuration you set in this screen takes priority than the Network Setting > NAT > Port
Forwarding screen.
Figure 8-4 Network Setting > NAT > DMZ
The following table describes the fields in this screen.
Table 8-3 Network Setting > NAT > DMZ
Enter the IP address of your network DMZ host, if you have one. 0.0.0.0
means this feature is disabled.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
8.4 The Sessions Screen
Use the Sessions screen to limit the number of concurrent NAT sessions each client can use.
Click Network Setting > NAT > Sessions to display the following screen.
To Next Page
Loading...
