LTE TDD B2268H
User Guide
Copyright © Huawei Technologies Co., Ltd.
This displays the name of the rule.
This displays the source IP addresses to which this rule applies. Please
note that a blank source address is equivalent to Any.
This displays the destination IP addresses to which this rule applies.
Please note that a blank destination address is equivalent to Any.
This displays the protocol type and a port range that define the service
to which this rule applies.
This field displays whether the rule silently discards packets (DROP),
discards packets and sends a TCP reset packet or an ICMP destination-
unreachable message to the sender (REJECT) or allows the passage of
packets (PERMIT).
Click the Edit icon to edit the rule.
Click the Delete icon to delete an existing rule. Note that subsequent
rules move up by one when you take this action.
10.4.1 The Add New ACL Rule/Edit Screen
Click Add New ACL Rule or the Edit icon next to an existing ACL rule in the Access Control
screen. The following screen displays.
Figure 11-6 Security > Firewall > Access Control > Add New ACL Rule/Edit
Each field is described in the following table.
To Next Page
Loading...
