Huawei MTS9300A - 3.5 Heat Exchanger HXC300 S

Figure 5-3 Connecting a communications cable
(1) RS485/RS232 port on the SMU (2) MON1 port on BBU
----End
5.2.3 NetEco Management
Networking Mode 1: FE Port
Step 1 Connect the FE port on the SMU by using a network cable.
Figure 5-4 Connecting a communications cable (over the FE port)
(1) NetEco terminal
(2) FE port on the SMU
----End
Networking Mode 2: RS485 Port
Step 1 Connect one end of a network cable to the RS485/RS232 port on the SMU.
Step 2 Connect the other end of the cable to the MON0 or MON1 port on Huawei BBU.
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 5 Installing Cables
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 32