Huawei MTS9300A - B Electrical Conceptual Diagrams

----End
8.10.4 (Optional) Setting Parameters Before Using SNMP
Management
Prerequisites
NO TE
You can set SNMP parameters remotely or locally on the WebUI.
Before setting SNMP parameters, obtain the information listed in Table 8-13 from
the SNMP-based NMS.
Table 8-13 Information obtained from the NMS
Information Description
SNMP Version SNMP version and port number used for communication between the
SMU and NMS. The SNMP version can be SNMPv1, SNMPv2c, or
SNMPv3.
SNMP Port Number
Read Community
Name
If you use SNMPv1 or SNMPv2c, enter the read and write community
names that comply with the NMS. Otherwise, the SMU will not connect
to the NMS.
The read community name must be dierent from the write community
name.
Write Community
Name
User Name To enhance the security, you need a user name and password for
authentication if you use SNMPv3. After the authentication succeeds, the
SMU can communicate with the NMS.
MD5/SHA Password
DES/AES Password
Trap Target Address IP address and port number used for reporting alarm trap packets.
Trap Port
Trap Community If you use SNMPv1 or SNMPv2c, this parameter is the community name
used for reporting alarm trap packets.
NO TE
● The standard protocols SNMPv1 and SNMPv2 have security risks. You are advised to use
the secure protocol SNMPv3.
● The standard encryption algorithms MD5 and DES have security risks. You are advised
to use the secure encryption algorithms SHA and AES.
Procedure
Step 1 Log in to the WebUI.
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 8 Commissioning
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 67