Huawei MTS9300A - Installing Three-Live Wire Input Power Cables

Figure 5-17 Installing a 220/380 V AC three-phase four-wire input power cable
(1) ACDB
----End
5.5.2 Installing Three-Live Wire Input Power Cables
Procedure
NO TICE
When changing the input system of the AC power distribution box (PDB), move
the short-circuit copper bar, as shown in the following
gures.
Step 1 Remove the insulation cap from the short-circuit copper bar.
Step 2 Install the short-circuit copper bar in the corresponding position and install the
short-circuiting bar as required.
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 5 Installing Cables
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 40