6 Installing Batteries and Cables
● Smoking and sparks are prohibited near batteries.
● Switch o battery circuit breakers before installing batteries.
● Comply with regulations and warnings of the battery manufacturer.
● Use tools with insulated handles, otherwise, batteries may be burnt out and
personal injury may occur.
● During battery operations, wear goggles, rubber gloves, and protective clothes.
Remove conductive articles such as watches, bracelets, and rings.
● If battery acid gets in the eyes, rinse with cold water for more than 15 minutes
and seek medical advice immediately. If battery acid contacts skin or clothing,
wash with soap and water immediately.
● Do not use metal to simultaneously contact two or more battery terminals or
simultaneously contact battery terminals and objects (such as the battery
compartment) that have been grounded. Otherwise, transient short circuits
may occur, which may further generate sparks or explosion.
● During battery installation, never short-circuit or reversely connect positive and
negative battery terminals. Connect the negative battery cable before the
positive battery cable.
● Secure battery cables to a torque
specied in battery documentation. Loose
connections will result in excessive voltage drop or cause batteries to burn out
when the current is large.
Ensure that batteries are from the same manufacturer, of the same model, and in
the same batch. Do not use a combination of old and new batteries.
6.1 Installing Lithium Batteries and Cables
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 6 Installing Batteries and Cables
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 46
To Next Page
Loading...
