Figure 5-9 Preparing a cord end terminal
(1) Cable (2) Cord end terminal (3) Crimping tool
Step 2 Install DC output power cables.
1. Insert a at-head screwdriver (2 mm wide) into the holes for DC output
circuit breakers.
2. Connect DC output power cables to the corresponding DC output circuit
breakers.
3. Remove the
at-head screwdriver.
Figure 5-10 Installing DC output power cables
(1) DC load
----End
5.4 Installing Cables for an Intelligent Power
Distribution Unit
The methods for installing cables between the intelligent power distribution unit and other
power subracks are similar. The following uses one of them as an example.
Procedure
Step 1 Install power cables for the intelligent power distribution unit.
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 5 Installing Cables
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 36
To Next Page
Loading...
