Huawei MTS9300A - 3.6.3 Temperature Sensor; 3.7 Light

Figure 5-8 Installing DC output power cables
(1) DC load
----End
Connecting DC Output Power Cables to 63 A Circuit Breakers
Step 1 Use cables (cross-sectional area: 1.5–16 mm
2
) and cord end terminals to prepare
DC output power cables.
Table 5-2 Preparing cables
Cross-Sectional
Area
Recommended Cord End Terminal
Specications
Recommended Bare Wire
Specications
1.5 mm
2
Pre-insulated and with an insertion
depth of 18 mm
16 mm
2
NOTICE
Cord end terminals are
recommended. When bare wires are
used, you are advised to add heat
shrink tubing to ensure that the wire
ends are not split.
4 mm
2
Pre-insulated and with an insertion
depth of 18 mm
10 mm
2
Pre-insulated and with an insertion
depth of 18 mm
16 mm
2
Pre-insulated and with an insertion
depth of 18 mm (supports bare wire
installation)
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 5 Installing Cables
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 35