Huawei MTS9300A - A.3 EMC Specifications

Procedure
Step 1 Set the port mode, communications protocol type, baud rate, and communications
address on the SMU's LCD.
Table 8-9 Communications parameters
Main Menu Second-
Level Menu
Third-
Level
Menu
Fourth-Level
Menu
Fifth-Level
Menu
Default
Value
Settings
Parameters
Settings
Comm.
Parameters
Serial
Port
Northbound Port Mode Manual Manual
Protocol
Type
NOTE
Protocol
Type is
displayed
only when
Port Mode is
set to
Manual.
M/S
Protocol
M/S
Protocol
M/S
Protocol
Baud Rate - 9600 9600
Comm.
Address
- 3 3
----End
8.10.3 (Optional) Setting Parameters Before Using NetEco
Networking Mode 1: FE Port
Step 1 Apply to the site or equipment room network administrator for a
xed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the SMU's LCD.
Table 8-10 IP parameters
Main
Menu
Second-Level
Menu
Third-Level
Menu
Default Value Settings
Setting
Wizard
Network
Parameters
IP Address 192.168.0.10 Set this parameter
according to the IP address
assigned by the network
administrator.
Subnet Mask 255.255.255.0 Set this parameter
according to the subnet
mask provided by the
network administrator.
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 8 Commissioning
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 65