Huawei MTS9300A - Page 72

Main
Menu
Second-Level
Menu
Third-Level
Menu
Default Value Settings
Default
Gateway
192.168.0.1 Set this parameter
according to the gateway
address provided by the
network administrator.
Step 3 Set the IP Addresses and Ports for the active servers of the NetEco on the SMU's
LCD.
Table 8-11 NetEco parameters
Main Menu Second-
Level Menu
Third-Level
Menu
Fourth-Level
Menu
Default
Value
Settings
Parameters
Settings
Comm.
Parameters
Network
Parameters
NetEco Primary
IP
192.168.0.10 Set an IP
address for the
active NetEco
server.
NetEco Port
Number
31220 Set a port for
the NetEco.
----End
Networking Mode 2: RS485 Port
Step 1 Set Port Mode to Manual, Protocol Type to M/S Protocol, Baud Rate to 9600,
and Comm. Address to 3.
Table 8-12 Communications parameters
Main Menu
Second-
Level
Menu
Third-
Level
Menu
Fourth-Level
Menu
Fifth-Level
Menu
Default
Value
Settings
Parameters
Settings
Comm.
Parameters
Serial
Port
Northbound Port Mode Automatic Manual
Protocol Type
NOTE
This parameter
is displayed
only when Port
Mode is set to
Manual.
M/S
Protocol
M/S
Protocol
M/S
Protocol
Baud Rate - 9600 9600
Comm.
Address
- 3 3
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide 8 Commissioning
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. 66