Huawei MTS9300A - Page 6

5.2.3 NetEco Management....................................................................................................................................................... 32
5.2.4 Third-Party NMS Management (over SNMP)......................................................................................................... 33
5.3 Installing DC Output Power Cables................................................................................................................................ 34
5.4 Installing Cables for an Intelligent Power Distribution Unit..................................................................................36
5.5 Installing an AC Input Power Cable................................................................................................................................39
5.5.1 Installing Three-Phase Four-Wire Input Power Cable........................................................................................... 39
5.5.2 Installing Three-Live Wire Input Power Cables....................................................................................................... 40
5.5.3 Installing Dual–Live Wire Input Power Cables........................................................................................................ 42
5.5.4 Installing Single-Phase Input Power Cables............................................................................................................. 43
6 Installing Batteries and Cables.......................................................................................... 46
6.1 Installing Lithium Batteries and Cables........................................................................................................................ 46
6.1.1 Installing Lithium Batteries............................................................................................................................................ 47
6.1.2 Installing Lithium Battery Cables................................................................................................................................. 48
7 Verifying the Installation.................................................................................................... 51
7.1 Checking Hardware Installation.......................................................................................................................................51
7.2 Checking Electrical Connections...................................................................................................................................... 51
7.3 Checking Cable Installation............................................................................................................................................... 51
8 Commissioning.......................................................................................................................52
8.1 Connecting the Lithium Battery Supply........................................................................................................................ 52
8.2 Setting the Display Language.......................................................................................................................................... 53
8.3 Setup Wizard.......................................................................................................................................................................... 53
8.4 Setting the Date and Time................................................................................................................................................ 54
8.5 Setting the AC Input System............................................................................................................................................. 55
8.6 Setting the 57 V Constant Voltage Parameter........................................................................................................... 55
8.7 Setting DCDB Parameters.................................................................................................................................................. 55
8.8 Setting AC Peak Clipping Parameters............................................................................................................................ 56
8.9 Setting Sensor Parameters.................................................................................................................................................57
8.10 Setting Communications Parameters.......................................................................................................................... 58
8.10.1 (Optional) Setting Parameters for WebUI Management..................................................................................58
8.10.2 (Optional) Setting Parameters Before Using U2000-SPM................................................................................64
8.10.3 (Optional) Setting Parameters Before Using NetEco......................................................................................... 65
8.10.4 (Optional) Setting Parameters Before Using SNMP Management............................................................... 67
8.11 Connecting the AC Power Supply................................................................................................................................. 68
A Subsequent Operations....................................................................................................... 69
B Preparing Terminals............................................................................................................. 70
C Associations Between Alarms and Dry Contacts on the UIM.....................................71
D Acronyms and Abbreviations............................................................................................. 73
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide Contents
Issue 01 (2021-05-30) Copyright © Huawei Technologies Co., Ltd. v