Huawei Quidway S2000-EI Series - Page 9

Installation Manual
Quidway S2000-EI Series Ethernet Switches Table of Contents
ii
3.4.4 Connecting Ground Wire......................................................................................... 3-7
3.5 Connection of Console Cable............................................................................................ 3-9
3.5.1 Console Cable......................................................................................................... 3-9
3.5.2 Connecting Console Cable ................................................................................... 3-10
3.6 Installation/Removal of Optional Interface Modules........................................................ 3-11
3.6.1 Installing Optional Interface Module...................................................................... 3-11
3.6.2 Removing Optional Interface Module.................................................................... 3-12
3.7 Installation Verification..................................................................................................... 3-12
Chapter 4 Powering on Switch for the First Time...................................................................... 4-1
4.1 Establish configuration environment.................................................................................. 4-1
4.2 Connecting the Console Cable.......................................................................................... 4-1
4.3 Setting Terminal Parameters............................................................................................. 4-1
4.4 Boot Switch........................................................................................................................ 4-5
4.4.1 Check before Powering on the Switch.................................................................... 4-5
4.4.2 Powering on the Switch........................................................................................... 4-5
Chapter 5 BootROM and Host Software Loading ...................................................................... 5-1
5.1 Introduction to Loading Approaches.................................................................................. 5-1
5.2 Local Software Loading .....................................................................................................5-1
5.2.1 Boot Menu............................................................................................................... 5-2
5.2.2 Loading Software from Console Port Using XModem ............................................ 5-3
5.2.3 Loading Software from Ethernet Port Using TFTP ................................................. 5-8
5.2.4 Loading Software from Ethernet Port Using FTP.................................................... 5-9
5.3 Remote Software Loading ............................................................................................... 5-11
5.3.1 Remote Loading Using FTP.................................................................................. 5-11
5.3.2 Remote Loading Using TFTP................................................................................ 5-12
5.4 Dealing with Load Failure ................................................................................................ 5-12
5.5 Dealing with Missing of Password ................................................................................... 5-13
Chapter 6 Maintenance and Troubleshooting............................................................................ 6-1
6.1 Power System Failure........................................................................................................6-1
6.2 Configuration System Failure ............................................................................................ 6-1
Chapter 7 Optional Interface Modules......................................................................................... 7-1
7.1 1-Port 100Base-FX Modules ............................................................................................. 7-1
7.1.1 Module Panel and LEDs ......................................................................................... 7-1
7.1.2 Module Interface Fiber ............................................................................................ 7-2
7.2 1-Port 100Base-T PoE Interface Module (S2016-EI) ........................................................ 7-3
7.2.1 Module Panel and LEDs ......................................................................................... 7-3
7.2.2 Interface Attributes.................................................................................................. 7-4
Appendix A Lightning Protection of the Switch.........................................................................A-1
A.1 Installation of Lightning Arrester for AC Power (Socket Strip with Lightning Protection)..A-1
A.2 Installation of Lightning Arrester for Network Port.............................................................A-2