EasyManua.ls Logo

Huawei Quidway S2700 series - Page 121

Huawei Quidway S2700 series
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Configure public servers and hosts for the cluster.
Data Preparation
To complete the configuration, you need the following data:
l Management VLAN ID of the cluster, that is 10
l IP address of VLANIF 10, that is 1.0.0.1/8
l Address pool of the cluster, that is 10.0.0.0/8
l IP address of the administrator in the cluster, that is 10.0.0.1/8
l MAC addresses of devices, as shown in Figure 3-3
l IP addresses of servers and hosts, as shown in Figure 3-3
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface ethernet 0/0/1
[Administrator-1-Ethernet0/0/1] port link-type trunk
[Administrator-1-Ethernet0/0/1] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/1] quit
[Administrator-1] interface ethernet 0/0/2
[Administrator-1-Ethernet0/0/2] port link-type trunk
[Administrator-1-Ethernet0/0/2] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/2] quit
[Administrator-1] interface ethernet 0/0/3
[Administrator-1-Ethernet0/0/3] port link-type trunk
[Administrator-1-Ethernet0/0/3] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/3] quit
[Administrator-1] interface vlanif 10
[Administrator-1-Vlanif10] quit
# Configure member switch 1.
<Quidway> system-view
[Quidway] sysname Member-1
[Member-1] vlan 10
[Member-1-vlan10] quit
[Member-1] interface ethernet 0/0/1
[Member-1-Ethernet0/0/1] port link-type trunk
[Member-1-Ethernet0/0/1] port trunk allow-pass vlan 10
[Member-1-Ethernet0/0/1] quit
[Member-1] interface ethernet 0/0/2
[Member-1-Ethernet0/0/2] port link-type trunk
[Member-1-Ethernet0/0/2] port trunk allow-pass vlan 10
[Member-1-Ethernet0/0/2] quit
[Member-1] interface vlanif 10
[Member-1-Vlanif10] quit
# Configure member switch 2.
<Quidway> system-view
[Quidway] sysname Member-2
[Member-2] vlan 10
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
111

Table of Contents

Other manuals for Huawei Quidway S2700 series

Related product manuals