Step 3 Install the card in the switch.
1. Pull the ejector lever of the card 45 degrees outward. Gently push the card into the
chassis with your thumbs placed below the captive screws, until the screw on the front
panel is completely in the chassis.
NOTE
Front cards for the S3700-HI, S5700-HI, and S5710-HI have no screws. However, the installation
method is similar.
2. Push the ejector lever inward to lock the card.
3. Use a Phillips screwdriver to tighten the captive screws.
----End
6.3 Installing an Optical Module
Context
This section describes how to install an optical module. The method used to install a copper
transceiver module is the same, except that the copper transceiver module connects to a
network cable instead of optical fibers.
S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
6 Installing Modules
Issue 13 (2017-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
49
To Next Page
Loading...
