Huawei S2700 - Connecting Copper Cables

Figure 7-3 Connecting optical fibers to an optical module
To remove optical fibers from an optical module, gently push the fiber connector inward, and
then pull the fiber connector out while pressing the locking clips. Do not forcibly pull the
fiber connector. See Figure 7-4.
NOTE
If optical ports are densely populated, use the tweezers delivered with the switch to remove optical
fibers.
Figure 7-4 Removing optical fibers
1
2
Locking clip
Step 7 Arrange the optical fibers to make them parallel and bundle them with fiber binding tape at a
spacing of 150-300 mm (5.9-11.8 in.).
Step 8 Replace all the temporary labels on the optical fibers with permanent labels.
----End
7.4 Connecting Copper Cables
S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
7 Connecting a Switch
Issue 13 (2017-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
62