Huawei S2700 - Installing a Power Module in the RPS1800

9.2 Installing a Power Module in the RPS1800
Context
An RPS1800 that has 870 W PoE power modules installed can provide PoE power
redundancy or PoE power supply for a PoE switch, as shown in Figure 9-1.
Figure 9-1 RPS1800 providing PoE power for connected switches
~100-240V;50/60Hz;16 A
OUTPUT1 -53.5V/15A;12V/12.5A OUTPUT2 -53.5V/15A;12V/12.5A OUTPUT3 -53.5V/15A;12V/12.5A OUTPUT4 -53.5V/15A;12V/12.5A OUTPUT5 -53.5V/15A;12V/12.5A OUTPUT6 -53.5V/15A;12V/12.5A
870 WPoE Power Moudle
IP Phone PD
TOP
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
CONSOLE
25
26 27 28
MODE
STCK
SEPD
STAT
SYS
PWR
PoE
HUAWEI
S5700-28P-PWR-LI-AC
NOTE
When providing power for non-PoE switches, the RPS1800 does not need 870 W PoE power modules.
The 870 W PoE power modules and RPS cables are not hot swappable.
Tools and Accessories
l ESD wrist strap or ESD gloves
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. When wearing an ESD wrist strap, ensure that it is in
close contact with your wrist and grounded properly.
Step 2 Remove the filler panel from the slot into which the power module will be installed. Keep the
filler panel for future use.
Hold the upper edge of the filler panel and pull the filler panel downward to remove it. Do not
pull the filler panel horizontally.
S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
9 (Optional) Installing an RPS1800
Issue 13 (2017-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
69